Front Final Drive Overview

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Final Drive Components Location

Courtesy of AUDI OF AMERICA, LLC

Bolt
- 90 Nm +90°
- Replace
Front Subframe
Bolt
- Replace
Front Final Drive 0BM and 0C1
- Front final drive designation and allocation. Refer to FRONT FINAL DRIVE DESIGNATION 0BM AND 0C1 .
- Removing and Installing:
  - Vehicles with 3.0L TFSI engine. Refer to FRONT FINAL DRIVE, REMOVING AND INSTALLING .
  - Vehicles with a 3.0L TDI engine. Refer to FRONT FINAL DRIVE, REMOVING AND INSTALLING .
  - Vehicles with a 6.0L TDI engine. Refer to FRONT FINAL DRIVE, REMOVING AND INSTALLING
- The color markings on the flange and front Drive Axle must align with each other.
Right Drive Axle
- Removing and Installing Rear Suspension
Bolt
- Tightening Specifications Rear Suspension
Plate
Front Driveshaft
- Overview. Refer to FRONT DRIVESHAFT OVERVIEW .
Plate
Bolt
- Tightening Specifications Rear Suspension
Left Drive Axle
- Removing and Installing Rear Suspension
Nut
- 90 Nm +90°
- Replace
Bolt
- Replace
Nut
- 90 Nm +90°
- Replace