Front Driveshaft, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Seal -1- And Locking Ring -2-

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

Tightening specifications. Refer to FRONT DRIVESHAFT OVERVIEW .

-- Install a new O-ring -1- and new locking ring -2-.

-- Attach the Driveshaft to the front final drive.

Fig 2: Identifying Installed Position Marks

Courtesy of AUDI OF AMERICA, LLC

The markings on the Driveshaft and the final drive -arrow- must line up.

-- Install the Drive Axle on to the flange with a quick push being careful not to angle it. If it does not slide onto the flange, use a piece of wood -A-. Pull the Drive Axle to make sure it secure.

Fig 3: Identifying Installation Of Driveshaft

Courtesy of AUDI OF AMERICA, LLC

-- Attach the Driveshaft to the transfer case with new bolts -arrows-.

Fig 4: Identifying Driveshaft Bolts -Arrows-

Courtesy of AUDI OF AMERICA, LLC

-- Use the Counterhold - Kit - Multiple UseT10172 and adapters T10172/6.

-- Install the transmission carrier. Refer to TRANSMISSION CARRIER AND CONSOLE, REMOVING AND INSTALLING .