Bonded Rubber Bushing In Front Housing, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Vertical Alignment Of Small Hole And Large Recesses -Arrows-

Courtesy of AUDI OF AMERICA, LLC

-- Mount the bonded rubber bushing on the final drive in its installed position.

NOTE:

The small hole -A- and the larger recesses on the bonded rubber bushing -arrows- must be vertical to the final drive.

-- Install the bonded rubber bushing until it is fits into the center of the front final drive housing.

Fig 2: Identifying Tool Assembly To Install Bonded Rubber Bushing

Courtesy of AUDI OF AMERICA, LLC