Turbocharger Control Module 1 -J724-, REMOVING AND INSTALLING: Removing: Notes

Fig 1: Removing Engine Cover

Courtesy of AUDI OF AMERICA, LLC

-- Carefully pull the engine cover off the four retaining pins one after the other in direction of -arrows-.

-- Release the cover and pivot it to the side -arrow-.

Fig 2: Opening Cover Over Terminal 30 Wire Junction 2 -Tv22- -Arrow-

Courtesy of AUDI OF AMERICA, LLC

-- Connect the E-Positioner Service Kit - E-Box VAS6395A/1 or Tester for E-Positioner - E-Box VAS6395B/1 with Turbo E-Positioner Service Kit - Wire Set VAS6395/2 to positive terminal -2- and to the Ground (GND).

Procedure for Tester for E-Positioner - E-Box VAS6395B/1:

Fig 3: Identifying Electronic Unit (E-Box)

Courtesy of AUDI OF AMERICA, LLC

-- Select the software version using the ↑  -5- and ↓  -6- buttons.

-- Press the v  button -4- to confirm the software version.

Fig 4: Identifying Procedure For Tool For Replacing E-Positioner On Turbo VAS 6395/1A

Courtesy of AUDI OF AMERICA, LLC

Procedure for E-Positioner Service Kit - E-Box VAS6395A/1:

Fig 5: Identifying VAS 6395/1 Software Version

Courtesy of AUDI OF AMERICA, LLC

Check the software version of the E-Positioner Service Kit - E-Box VAS6395A/1:

If the correct software is loaded, the following will be displayed on the E-Positioner Service Kit - E-Box VAS6395A/1 (2 seconds after the voltage supply is connected):

1. > 1. START
2. 2. NEXT [>]

Continue with For both E-boxes.