Overview - Charge Air Cooler
WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, and 2013 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The illustration shows the left charge air cooler.
- Front Air Guide
- Attached to the charge air cooler
- Unclip it to the side to remove
- O-ring
- Replace if damaged or leaking
- Air Guide Hose
- To turbocharger
- Installing. Refer to Figure.
- Bolt
- Tightening specification: 9 Nm
- Bolt
- Tightening specification: 9 Nm
- Air Guide Hose
- To the right charge air cooler
- Installing. Refer to Figure.
- Connection
- Bolt
- Tightening specification: 9 Nm
- O-ring
- Replace
- Charge Air Pressure Sensor -G31- / Intake Air Temperature Sensor -G42-
- Removing and installing. Refer to Charge Air Pressure Sensor -G31- / Intake Air Temperature Sensor -G42-, REMOVING AND INSTALLING .
- Bolt
- Tightening specification: 5 Nm
- Air Guide Hose
- To the Intake Manifold
- Installing. Refer to Figure.
- O-ring
- Replace
- Charge Air Cooler
- Removing and installing. Refer to CHARGE AIR COOLER, REMOVING AND INSTALLING .