Camshaft Position Sensor -G40- / -G163-, Removing And Installing: Removing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Camshaft Position Sensor -G40- Connector Location

Courtesy of AUDI OF AMERICA, LLC

-- Remove the front engine cover, refer to ENGINE COVERS, REMOVING AND INSTALLING .

-- Disconnect the connector -1-.

-- Remove the bolt -arrow- and the Camshaft Position Sensor -G40- (cylinder bank 1).

-- Disconnect the connector -1-.

Fig 2: Camshaft Position Sensor 2 -G163- Connector Location

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -arrow- and the Camshaft Position Sensor 2 -G163- (cylinder bank 2).