Fuel Level Sensor 2 -G169-, CHECKING: Notes
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi A6 Quattro, 2017 Audi A6, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Analog/Digital Multimeter :FLU83III
- Connector Test Set :VAG1594D
- Elbow Assembly Tool :T10118
-- Move the right front seat all the way forward.
-- Remove the rear bench seat. Refer to OVERVIEW - SEAT BENCH/SINGLE SEAT .
-- Fold the insulation mat near the locking flange cover to the side.
-- Remove the bolts -arrows- and the locking flange cover.
NOTE:
Ignore item -1-.
-- Open the connector locking mechanism with the :T10118 and disconnect the connector -2- on the locking flange.
CAUTION:
There is the risk of incorrect measurements.
- When measuring the resistance values at "fuel tank empty", an inaccurate measurement, can occur because there may be some fuel left in the other chamber. The remaining fuel must be extracted after opening the locking flange in order to attain the following measured values. Refer to Fuel Level Sensor 2 -G169-, REMOVING AND INSTALLING .