LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2009 >> Q5 >> Repair and Diagnosis >> External Pages >> Different car >> Section 956 (Fuel System (Service Information - CGXB, CAEB, CEUC, CHJA, CRDB, CAED, CTUA, CTGE, CREC, CWUB, CYNB, CWUC, CREH)) >> Fuel Supply >> Fuel Delivery Unit/Fuel Level Sensor >> Fuel Level Sensor -G-, REMOVING AND INSTALLING >> Installing

Fuel Level Sensor -G-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi A6 Quattro, 2017 Audi A6, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following: 

-- Insert the Fuel Level Sensor -G- in the guides on the fuel delivery unit and push down until it engages.

-- Connect the connector. Make sure it is secure.

-- Install the fuel delivery unit. Refer to FUEL DELIVERY UNIT/FUEL LEVEL SENSOR, REMOVING AND INSTALLING .

-- Connect the batter while doing so follow all steps after connecting the battery. Refer to BATTERY .

scientia non olet · About LEMON Manuals