Leak Detection Pump, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi A6 Quattro, 2017 Audi A6, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Follow all safety precautions. Refer to SAFETY PRECAUTIONS .
-- Follow the guidelines for clean working conditions. Refer to CLEAN WORKING CONDITIONS .
-- Remove the rear left underbody trim panel. Refer to UNDERBODY TRIM PANEL .
-- Remove the EVAP canister. Refer to EVAP CANISTER, REMOVING AND INSTALLING .
-- Loosen the clamp and remove the breather line -2-.
-- Remove the bolts -1-.
-- Remove the Fuel Tank Leak Detection Control Module -J909- -3- from the EVAP canister in direction of -arrow-.