Balance Shaft, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2016 Audi S4, 2015 Audi S5, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
- Tightening specification: 60 Nm.
- Crankshaft -1- secured in "Top Dead Center (TDC)" using Crankshaft Locking Pin T40069.
Install in reverse order of removal. Note the following:
NOTE:
The balance weights can only be positioned one way on balance shaft.
-- Install the power take-off drive chain. Refer to POWER TAKE-OFF DRIVE CHAIN, REMOVING AND INSTALLING .
-- Install the lower timing chain cover. Refer to LOWER TIMING CHAIN COVER, REMOVING AND INSTALLING .
-- Install the belt pulley side sealing flange. Refer to SEALING FLANGE, REMOVING AND INSTALLING, BELT PULLEY SIDE .