LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2009 >> Q5 >> Repair and Diagnosis >> External Pages >> Different car >> Section 533 (Controls & Housing - S TRONIC Transmission 0B5 (Sedan)) >> 34 Controls, Housing >> Selector Mechanism >> Overview - Selector Lever Cable

Overview - Selector Lever Cable

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2018 Audi S6, 2017 Audi S6, 2016 Audi S6, 2016 Audi S4, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Selector Lever Cable Overview
GWWA34-10424Courtesy of AUDI OF AMERICA, LLC
  1. Clip
    • For the selector lever cable on the selector mechanism function unit
  2. O-Ring
    • Replace
  3. Bolt
    • 13 Nm
    • For selector lever cable adjustment
    • Attached to the selector mechanism function unit
  4. Selector Lever Cable
    • Do not bend
    • Different versions depending on the vehicle .
    • Removing and installing. Refer to SELECTOR LEVER CABLE, REMOVING AND INSTALLING 
    • The selector lever cable must be replaced if the rubber grommet is damaged.
    • Lubricate the ball socket lightly with Polycarbamide Grease G 052 142 A2 before installing.
    • Make sure the rubber grommet on the transmission side is not twisted when installing.
    • Adjusting. Refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING 
      • Perform "Guided Functions  " using the Vehicle Diagnostic Tester after adjusting the selector lever cable. Refer to TRANSMISSION GUIDED FUNCTIONS .
  5. Selector Lever
  6. Clip
    • For attaching the selector lever cable to the cable bracket
    • Lock nut 13 Nm depending on the version
  7. Cable Mounting Bracket
  8. Bolt
    • 8 Nm
  9. Bolt
    • 8 Nm
scientia non olet · About LEMON Manuals