Bracket/reservoir installation location
WARNING: This page is about a different variant/trim than selected.
The bracket - 4 - with reservoir is located near level control system air supply unit - 2 -.
1 - Bolt, 20 Nm
3 - Washer (only for the front bolt)
To replace the reservoir, remove the following parts:
- Left front section of front wheel housing liner →
- Left air filter →
- for 4.2 LITER V8 4V ENGINE MECHANICAL, ENGINE CODE(S): BVJ
- for 4.2 LITER V8 5V ENGINE MECHANICAL, ENGINE CODE(S): BFM
- for 5.2 LITER 10-CYL. 4V ENGINE MECHANICAL, ENGINE CODE(S): BSM
- for 6.0 LITER 12-CYL. 4V ENGINE MECHANICAL, ENGINE CODE(S): BSB
- Bring lock carrier into service position → .