Transfer case gear oil, checking and topping off
WARNING: This page is about a different variant/trim than selected.
Special tools, testers and auxiliary items required
- Drip tray V.A.G 1306
- Safety glasses
Test conditions
- Gear oil temperature at approx. 20°C (room temperature).
Requirements
- To ensure vehicle is absolutely level, drive onto a hoist or over a service pit.
NOTE:
- If lifting the vehicle on a hoist with wheels off the ground, the vehicle jack mode must be activated → 43 - Self Leveling Suspension
- Remove rear sound insulation panels, by removing bolts - 3 - and - 4 -.
- Place drip tray V.A.G 1306 under transmission.
CAUTION:
Wear eye protection.
- Remove oil inspection and filler plug - C -.
NOTE:
- The oil inspection and filler plug - C - is located above the crossmember for the transmission and is therefore difficult to access.
If gear oil drips from the opening, oil level - arrow - in transfer case is OK.
- Top off gear oil, if necessary. Specification → Transfer case .
NOTE:
- Always replace oil inspection and filler plug.
- Install new oil inspection and filler plug - C -.
Tightening torque
| Component | Nm |
|---|---|
| Oil inspection and filler plug | 20 |