Front final drive gear oil, topping off after repairs
WARNING: This page is about a different variant/trim than selected.
Special tools, testers and auxiliary items required
- Drip tray V.A.G 1306
- Safety glasses
Conditions
- Gear oil temperature at approx. 20°C (room temperature).
Topping off
- Make sure vehicle is absolutely level, drive onto a hoist or over a service pit.
NOTE:
- If lifting the vehicle on a hoist with wheels off the ground, the vehicle jack mode must be activated → 43 - Self Leveling Suspension
- Place drip tray V.A.G 1306 under the transmission.
- Remove inspection plug - arrow -.
- Fill front final drive with oil (specification → Capacities ) slowly over a period of at least 5 minutes until oil drips from bottom of inspection hole.
NOTE:
- A filling time of at least 5 minutes is required so that the internal oil level between the differential and oil fill space can equalize.
- Replace O-ring of inspection plug.
- Tighten inspection plug to 35 Nm.
NOTE:
- It is not necessary to check the oil level again at this stage.