Check ignition key withdrawal lock

• To reach position "ignition on" , briefly turn ignition key lightly toward right.
• Press brake pedal and hold.

• It must be possible to shift selector lever out of position "P" without "hitching" while locking button on selector lever handle is pressed.

• Switch ignition off.

• It should not be possible to remove ignition key when selector lever is in any other position than "P".

• Place selector lever in position "P".
• Remove ignition key.

• It must be possible to remove ignition key only in position "P".
• Selector lever cannot be shifted out of position "P" with locking button pressed and foot brake operated.

If ignition key withdrawal lock does not function as described:

If ignition key withdrawal lock does not function as described, check vehicle with Vehicle Diagnosis, Testing and Information System VAS 5051 in "Guided Fault Finding" function.