Heated Oxygen Sensor (HO2S) 3 -G285- (before catalytic converter, left front), removing and installing: Installing
WARNING: This page is about a different variant/trim than selected.
Perform installation in the reverse order of removal, noting the following:
NOTE:
- New oxygen sensors are coated with assembly paste; the paste must not get into slots on the oxygen sensor body.
- When re-installing a used oxygen sensor, coat the threads with hot bolt paste . This paste must not come into contact with the slots on the oxygen sensor body.
- During installation, all cable ties must be re-installed at the same location.
- Wires of oxygen sensors must always be secured in the same position when installing so that contact with the exhaust pipe is avoided.
- Install front part of left front wheelhouse liner → 66 - EXTERIOR EQUIPMENT .
- Deactivate vehicle lifting mode → 43 - Self Leveling Suspension .