Right intake manifold side part, removing and installing: Notes

Fig 1: Pulling Engine Cover At Rear And Middle Upward And Off & Pulling Engine Cover Forward And Off Of Intake Manifold

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Carefully pull engine cover upward and off at rear - arrows 1  -.
• Pull engine cover forward and off of intake manifold - arrows 2  -.

Fig 2: Mass Air Flow (MAF) Sensor G70 Electrical Connector, Upper Part Of Air Filter Housing Connections, Intake Manifold Air Duct Hose & Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Separate electrical connector - 1  - for Mass Air Flow (MAF) sensor -G70-.
• Disconnect air duct hose - 4  - at intake manifold.
• Unhook retainer for connections - 2  - and - 3  - at upper part of air filter housing.
• Remove bolts - arrows  -.

• Remove upper part of right air filter housing.

Fig 3: Electrical Connectors & Vacuum Hoses

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Pull off vacuum hose - 4  - from Evaporative Emission (EVAP) canister purge regulator valve -N80-.

NOTE:

• Ignore - Pos. 1 to 3  - in the illustration.

Fig 4: Vacuum Hose, Bolts, Crankcase Breather Hoses & Throttle Valve Control Module J338 Electrical Connection

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Disconnect electrical connection - 6  - at Throttle valve control module -J338-.
• Disconnect vacuum hose - 1  -.
• Pull off hoses - 4  - and - 5  - for crankcase breather.
• Remove bolts - 2  - and - 3  -.

• Remove right intake manifold side part.