Left intake manifold side part, removing and installing: Notes
WARNING: This page is about a different variant/trim than selected.
Fig 1: Pulling Engine Cover At Rear And Middle Upward And Off & Pulling Engine Cover Forward And Off Of Intake Manifold
- Carefully pull engine cover upward and off at rear - arrows 1 -.
- Pull engine cover forward and off of intake manifold - arrows 2 -.
- Disconnect hose - 1 - from air duct hose.
- Remove left air duct hose - arrows -.
Fig 3: Throttle Valve Control Module 2 J544 Electrical Connection, Vacuum Lines, Crankcase Breather Hoses & Bolts
- Disconnect electrical connection - 7 - at Throttle valve control module 2 -J544-.
- Separate vacuum lines - 3 - and - 5 -.
- Pull off hoses - 2 - and - 6 - for crankcase breather.
- Remove bolts - 1 - and - 4 -.
- Remove left intake manifold side part.