Right combination valve for secondary air injection, removing and installing

Removing 

Fig 1: Mass Air Flow (MAF) Sensor G70 Electrical Connector, Upper Part Of Air Filter Housing Connections, Intake Manifold Air Duct Hose & Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Disconnect electrical connector - 1  - for Mass Air Flow (MAF) sensor G70.
• Disconnect air duct - 4  - at intake manifold.
• Unhook retainer for connections - 2  - and - 3  - at upper part of air filter housing.
• Remove bolts - arrows  -.

• Remove upper part of right air filter housing.

Fig 2: Air Duct & Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove air duct - 1  -.
• Remove bolts - arrows  -.
• Remove lower part of right air filter housing.

Fig 3: Combination Valve Pressure Hose & Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Pull hose - 1  - off from right combination valve for secondary air injection.
• Remove bolts - arrows  - and remove right combination valve for secondary air injection.

Installing 

Installation is in reverse order of removal. Note the following:

Tightening torque