Middle right coolant pipe, removing and installing: Removing
WARNING: This page is about a different variant/trim than selected.
- Engine/transmission assembly removed and attached to scissor lift platform VAS 6131.
- Remove right exhaust manifolds with catalytic converters → Right exhaust manifold with catalytic converters, removing and installing .
- Remove lower bolt - arrow - at right front coolant pipe.
- Rotate spindles of support elements - 1 - at left and right of engine carrier - 4 - completely downward.
NOTE:
- Ignore - 2 - and - 3 - in the illustration.
- Remove bolts - arrows - for engine mount at left and right.
- Remove engine carrier.
- Disconnect coolant hoses - arrows - at lower right coolant pipe.
- Remove bolts - 1 - and - 2 -.
- Pull lower right coolant pipe rearward and off of cylinder head.
- Disconnect electrical harness connector - arrow - at right engine mount.
- Remove bolts - 1 to 6 -.
- Remove engine support with engine mount.
- Remove bolts - 1 -.
- Pull middle right coolant pipe off from coolant hoses at positions indicated by - arrows -.