Lubrication System Components, Removing and Installing
WARNING: This page is about a different variant/trim than selected.
→ Oil Pan Lower Section, Removing and Installing
→ Oil Pump, Removing and Installing
→ Oil Pan Upper Section, Removing and Installing
→ Oil Filter Bracket, Assembly Overview
→ Oil Filter Housing, Removing and Installing
→ Engine Oil Cooler, Removing and Installing
→ Oil Pressure and Oil Pressure Switch, Checking
NOTE:
- If large quantities of metal shavings or abraded material are found in the engine oil while servicing the engine, the oil passages must be carefully cleaned to prevent resulting damage and the engine oil cooler must be replaced.
- The oil level must not be above the max. mark - danger of damage to catalytic converter!
Viscosity classes and oil specifications → 01 - MAINTENANCE .
Oil filling quantities → Fluid Capacity Chart.