Secondary Air Injection (AIR) Pump Motor V101 , removing and installing

WARNING: This page is about a different car, the 2006 Audi A8, 2005 Audi A8, and 2004 Audi A8. However, it is still accessible from the selected car via links, so may be relevant.

Removing

For vehicles with parking/auxiliary heater:

Fig 1: Removing Bolts For Exhaust Pipe Of Parking Heater/Auxiliary Heater On Noise Insulation

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove bolts - arrows - for exhaust pipe of parking heater/auxiliary heater on noise insulation.

All

Fig 2: Locating Mounting Parts And Removing Noise Insulation

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove noise insulation - 1 -.

Fig 3: Disconnecting Air Hoses

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect air hose - 1 -.
Disconnect air hose - 2 -.

Fig 4: Disconnecting Electrical Connector & Removing Secondary Air Injection (AIR) Pump Motor V101

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical connector - 1 -.
Remove Secondary Air Injection (AIR) Pump Motor V101 - arrows -.

Installing

Installation is in reverse order of removal, note the following:

Torque specifications

Component	Nm
Secondary Air Injection motor on bracket	10