Oil cooler, removing and installing
WARNING: This page is about a different car, the 2006 Audi A8, 2005 Audi A8, and 2004 Audi A8. However, it is still accessible from the selected car via links, so may be relevant.
- Remove engine → Engine, removing and installing .
- Remove right exhaust manifold → Right exhaust manifold, removing and installing .
- Remove oil filter housing → Oil filter housing, removing and installing
- Remove oil cooler - arrow -.
Installing
Installation is in reverse order of removal, note the following:
NOTE:
- Replace gaskets and O-rings.
- Install generator → 27 - BATTERY, STARTER, GENERATOR, CRUISE CONTROL
- Install right exhaust manifold → Right exhaust manifold, removing and installing
- Install coolant pipe to oil filter housing → Coolant pipe to oil filter housing, removing and installing
- Install torque support → Torque support (with torque support valve N382), assembly overview .
Torque specifications
Tightening torques → Oil cooler, assembly overview