Roller rocker lever, removing and installing
WARNING: This page is about a different car, the 2006 Audi A8, 2005 Audi A8, and 2004 Audi A8. However, it is still accessible from the selected car via links, so may be relevant.
Removing
- Engine removed → Engine, removing and installing .
- Remove camshafts and camshaft adjusters for right cylinder head → Camshafts and camshaft adjusters (left cylinder head), removing and installing and left cylinder head → Camshafts and camshaft adjusters (right cylinder head), removing and installing .
- Mark allocation of roller rocker lever and shafts for roller cam follower for re-installation.
- Remove bolts - arrows -.
- Thread a M6-bolt into hole in shaft for roller rocker lever.
- Remove shaft from cylinder head and remove roller rocker lever.
Installing
Installation is in reverse order of removal, note the following:
NOTE:
- Replace O-rings.
- Before installing, oil bearing areas for roller rocker lever.
- Install camshafts and camshaft adjusters → Camshafts and camshaft adjusters (right cylinder head), removing and installing for left cylinder head and → Camshafts and camshaft adjusters (left cylinder head), removing and installing for right cylinder head.
Torque specifications
| Component | Nm |
|---|---|
| Shaft for roller rocker lever to cylinder head | 10 |