Relay and fuse carrier in right luggage compartment, removing and installing

Fig 1: Releasing Retaining Springs And Pulling Comfort System Central Control Module J393 Downward Out Of Relay And Fuse Carrier

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing

With ignition switched off, disconnect battery Ground (GND) wire → Battery, disconnecting and connecting .
Remove right luggage compartment side trim cover.
Release retaining springs - arrows A - and pull Comfort System Central Control Module J393 downward out of relay and fuse carrier - arrow B -.

NOTE:

Fig 2: Identifying Harness Connectors, Bracket, Relay, Cover, And Retaining Springs

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Unclip harness connectors - 4 - and bracket - 3 - for additional fuses at relay and fuse carrier.
Remove relay - 2 - or control modules, then unclip respective relay carrier.
Release retaining springs - arrows - and open cover - 1 -.

Fig 3: Identifying Clip, Parking Aid Control Module J446, Mounting Frame, And Electrical Harness Connectors

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Sedan:

On vehicles with parking aid, remove right side trim → 70 - INTERIOR TRIM REMOVAL AND INSTALLATION .
Release clip - arrow A - and swivel Parking Aid Control Module J446 - 4 - out of mounting frame - arrow B -.
Harness connectors - 1 3 - remain connected.

Fig 4: Identifying Nuts, Bolts, And Mounting Frame

Courtesy of VOLKSWAGEN UNITED STATES, INC.

NOTE:

Fig 5: Removing Nuts And Bolt

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Vehicles with car jack bracket:

Fig 6: Removing Electrical Wires And Nuts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

All:

Fig 7: Releasing Retaining Springs And Pressing Fuse Holders Toward Rear Out Of Relay And Fuse Carrier

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Release retaining springs - arrows - and press fuse holders - 1 - and - 2 - toward rear out of relay and fuse carrier.

NOTE:

For exact assignment of relay and fuse carrier in right luggage compartment, refer to current wiring diagram → Electrical Wiring Diagrams, Troubleshooting and Component Locations.

Installing

Installation is performed in reverse order of removal, noting the following:

Tightening torques

Component		Nm
Relay and fuse carrier to body		3
Mounting frame for control modules	Bolt	2
	Nut	3
Electrical wires to relay and fuse carrier		9
Car jack bracket to body	Bolt	5
Nut	3