Fog lamp, removing and installing - Audi A6

Fig 1: Releasing Clip Using A Screwdriver And Removing Air Inlet Grille At Lower Part Of Bumper Cover

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing 

• Switch ignition off and remove ignition key.
• Turn light switch into "0" position.
• Release clip - arrow A  - using a screwdriver and remove air inlet grille - 1  - at lower part of bumper cover - arrows B  -.

Fig 2: Identifying Bolts And Fog Lamp Housing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove bolts - 1  - and - 2  -.
• Rotate fog lamp housing - 3  - counter-clockwise - arrow  - on left side, and rotate clockwise on right side.
• Remove fog lamp housing from bumper cover.
• Disconnect electrical harness connector.

Installing 

Installation is performed in reverse order of removal, noting the following:

• Adjusting fog lights 405.

Tightening torque