Base mount with right instrument panel fuse holder, removing and installing

Fig 1: Releasing Retaining Springs And Pressing Fuse Holders Toward Rear Out Of Base Mount

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing 

• With ignition switched off, disconnect battery Ground (GND) wire → Battery, disconnecting and connecting .
• Remove glove compartment → 68 - Interior Equipment Removal And Installation .
• Release retaining springs - arrows  - and press fuse holders - 1  - and - 2  - toward rear out of base mount.

Fig 2: Identifying Bolts And Base Mount

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove bolts - 1  - and - 2  -.
• Remove base mount in - direction of arrow  - from central tube for instrument panel.

Installing 

Installation is performed in reverse order of removal, noting the following:

• Install glove compartment → 68 - Interior Equipment Removal And Installation .
• Connect battery. Required actions Battery, disconnecting and connecting .

Tightening torque