Garage Door Opener Control Head E284, removing and installing

Removing 

• Remove font interior light module → Front interior light module, removing and installing .

Fig 1: Identifying Electrical Harness Connector, Clips, Interior Monitoring Sensor G273, And Interior/Reading Light

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Where installed, release clips - arrows  - and remove interior monitoring sensor/receiver module - 2  - from front interior light module.

Fig 2: Identifying Electrical Connection, Retaining Clips, And Front Interior Light Module

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Disconnect electrical connection - 2  -.
• Release retaining clips - arrows  - and remove Garage Door Opener Control Head E284 - 1  - from front interior light module.

Installing 

Install in reverse order of removal; noting the following:

• Reconnect electrical connection.
• Install font interior light module → Front interior light module, removing and installing .