Parking Aid Control Module J446, removing and installing - Avant

Fig 1: Removing Nuts And Bolt

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing

Vehicles with car jack bracket:

Fig 2: Removing Towing Eye From Mount For Vehicle Tool Kit

Courtesy of VOLKSWAGEN UNITED STATES, INC.

All:

Vehicles without bracket for control modules:

All:

Fig 3: Identifying Luggage Compartment Cargo Floor And Spare Wheel Cover

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove luggage compartment storage area floor - 1 - and cover for spare wheel - 2 -.

Fig 4: Identifying Tie-Downs, Retaining Track, And Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Push tie-downs - 2 - together in retaining track - 1 - so that they do not rest above bolts.
Unscrew bolts - arrow - and remove retaining track.
Disengage side luggage compartment trim in lower area → 70 - INTERIOR TRIM REMOVAL AND INSTALLATION .

Fig 5: Identifying Clip, Swivel Parking Aid Control Module J446, And Electrical Harness Connector

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Release clip - arrow - and swivel Parking Aid Control Module J446 - 4 - out of mounting frame.
Disconnect electrical harness connectors - 1 3 -.

Installing

Installation is performed in the reverse order of removal.

Tightening torques

Component		Nm
Retaining track for tie-down to body		4
Mount for vehicle tool kit to body		7
Car jack bracket to body	Bolt	5
Nut	3