Fastener Tightening Specifications
| Components | Bolt Size | Nm |
|---|---|---|
| Bumper Cover to Bracket | 1.5 | |
| Car Jack Bracket to Body | ||
| Screw | 5 | |
| Nut | 3 | |
| Clamping Bracket to Secure Rear Lid Lamp to the Rear Lid, Cap Nut | 3.5 | |
| Cover to Mirror Mount | 1 | |
| Cruise Control Switch | .65 | |
| Daytime Running Lamp to Bumper | 2 | |
| Exterior Mirror Entry Lamps | 1 | |
| Exterior Rearview Mirror Turn Signal Bulb | .9 | |
| Fog Lamp Housing to Bumper Cover | 1.5 | |
| Headlamp Housing | 8 | |
| Headlamp Power Output Stages | 1 | |
| Headlamp Range Control Positioning Motor | 1 | |
| HID Headlamp Control Module | 1 | |
| LED for Entry Light in Exterior Mirror To Cover | 1 | |
| Lower Cover | 1 | |
| Mount for Vehicle Tool Kit to Body | 7 | |
| Outer Rear Lid Lamp, Cap Nut | 3.5 | |
| Power Output Stage | 1 | |
| Reservoir for Power Steering to Bracket | 9 | |
| Retainer | 3 | |
| Retaining Track for Tie-Down to Body | 4 | |
| Turn Signal Switch | .65 | |
| Windshield Wiper/Washer Switch | .65 | |
| Avant | ||
| Clamping Bracket for Securing Bulb Socket and Housing at Rear Lid | 3.5 | |
| Clamp Mounting for Securing Housing at Rear Lid, Nut | 3.5 | |
| Clamp Mounting to Secure the Inner Rear Lid Lamp to the Rear Lid, Nut | 3.5 | |
| Housing, Cap Nut | 3.5 | |
| Outer Rear Lid Lamp, Cap Nut | 3.5 | |
| Retaining Element for Aligning Housing to Body Contour, Nut/Bolt | 2.5 | |
Tightening Specification, Steering Column Trim
- Lower steering column switch trim
- Upper steering column switch trim
- Bolt - 0.6 Nm
- Bolt - 0.6 Nm
- Handle for manual steering column adjustment
- Bolt - 3.5 Nm