Setting Device Basic Set :VAS6430/1 CONVERTING, FOR THE CALIBRATION PROCEDURE

Special tools and workshop equipment required 

• Setting Device Basic Set:VAS6430/1 

Before performing the calibration procedure, check location of the versicle slots on the :VAS6430/1  . The :VAS6190A  may need to be adapted before performing the calibration.

The :VAS6430/1  must be adapted before the adjustment procedure. If this is done during the adjustment procedure, the pre-calibration on the :VAS6430/1  must be repeated.

-- For the adjustment procedure, the vertical slits in mounts -1 through 4- must be inserted so that laser beam is approximately centered vertically when it contacts the sensor lens.

Fig 1: Identifying VAS 6190 And Vertical Slits In Mounts -1- Through -4-

Courtesy of AUDI OF AMERICA, LLC

-- The original nut at the top of the horizontal slits must be replaced with a standard nut -3-.

Fig 2: Identifying Mirror -1-, Vertical Slits -2- And Bolt -3-

Courtesy of AUDI OF AMERICA, LLC

-- The mirror at the center -1- must be removed and re-installed all the way to the left in direction of -arrow- near the vertical slits -2-.

Fig 3: Identifying Mirror -1-, Mirror Adjustment Knob And Vertical Slits -2-

Courtesy of AUDI OF AMERICA, LLC

-- Then the mirror -1- must be slide on horizontal slits as far as stop on vertical slits -2-.

Fig 4: Identifying Mirror -1-, Vertical Slits -2- And Bolt -3-

Courtesy of AUDI OF AMERICA, LLC