ACC, CALIBRATING, CALIBRATION PROCEDURE WITH Setting Device Basic Set :VAS6430/1: Notes
Special tools and workshop equipment required
- Setting Device Basic Set:VAS6430/1
- ACC Adjuster:VAS6190/2
- Vehicle Diagnostic Tester
- Wheel Alignment Computer
Before driving the vehicle onto the alignment stand, check if there is enough space between the vehicle and the :VAS6430/1 . The distance between the :VAS6430/1 and the vehicle must be 120 cm ± 5 cm.
If there is not enough space, drive vehicle the backward on the alignment stand in order to be able to use the space.
Before performing the calibration procedure, check the position of the calibration mirror and adjust it if necessary.
The :VAS6430/1 must be adapted before the adjustment procedure. If this is done during the adjustment procedure, the pre-calibration on the :VAS6430/1 must be repeated.
- Before beginning the adjustment, check the DTC memory and correct any malfunctions present.
The adjustment procedure is described here using the :VAS6430/1 .
Do not perform the steps under "Calibration procedure without a previous axle alignment" if an axle alignment has already been performed.