Adhesive Tape Surfaces
- The Vehicle Must Be At Room Temperature Before The Installation Of Self-Adhesive Cover, Door Seal Molding, etc. When Using Adhesive Tape.
- The Adhesive Surfaces On The Body Must Be Free Of Dirt And Grease.
- Clean The Adhesive Surfaces Using Cleaning Solution:D 009 401 04 .
- Apply Bonding Agent:D 355 205 A2 On The Surface On The Body Side Using The Applicator:D 009 500 25 And Let Dry.
- Warm The Adhesive Areas To Approximately 40 °C (104 °F) Using A Hot Air Blower.
- After Installing The Covers With Adhesive Tape, Use A Roller And Press The Adhesive Tape One More Time To Make Sure It Is On Securely.
- After That, Pull On The Adhesive Tape By Hand Just To Make Sure It Is On.