Acc Setting Device:Vas 6190, Converting For Adjustment Procedure

Special Tools And Workshop Equipment Required

ACC Adjustment Device:VAS 6190

NOTE:

Before Performing Adjustment, Check In Which Mount The Vertical Slits On The :VAS 6190 Are Located. :VAS 6190 May Have To Be Adapted Before Performing Adjustment.

The :VAS 6190 must Be Adapted Before Adjustment Procedure. If This Is Done During The Adjustment Procedure, The Pre-Calibration On The :VAS 6190 Must Be Repeated.

-- For The Adjustment Procedure, The Vertical Slits In Mounts -1- Through -4- Must Be Inserted So That Laser Beam Is Approximately Centered Vertically When It Contacts The Sensor Lens.

Fig 1: Identifying VAS 6190 And Vertical Slits In Mounts -1- Through -4-

Courtesy of AUDI OF AMERICA, LLC

-- The Original Nut At The Top Of The Horizontal Slits Must Be Replaced With A Standard Nut -3-.

Fig 2: Identifying Mirror -1-, Vertical Slits -2- And Bolt -3-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The Original Nut At The Top Of The Horizontal Slits Must Be Replaced With A Standard Nut So That The Mirror Can Be Slide Far Enough To The Center.

-- The Mirror At The Center -1- Must Be Removed And Re-Installed All The Way To The Left -Arrow- Near The Vertical Slits -2-.

Fig 3: Identifying Mirror -1-, Mirror Adjustment Knob And Vertical Slits -2-

Courtesy of AUDI OF AMERICA, LLC

-- Then The Mirror -1- Must Be Slide On Horizontal Slits As Far As Stop On Vertical Slits -2-.

Fig 4: Identifying Mirror -1-, Vertical Slits -2- And Bolt -3-

Courtesy of AUDI OF AMERICA, LLC