Parking brake lever trim, assembly overview

1 - Parking brake lever trim

• Removing 

• Apply parking brake firmly.
• Remove parking brake handle → Parking brake handle, removing and installing .
• Using a small screwdriver, press fastener - 2  - outward at left and right and pull parking brake lever trim out of its retainer tabs - 6  - and its mounts - 3  -.

• Installing 

• Engage parking brake lever trim - 1  - in its rear mounts - 3  -.
• Press parking brake lever trim - 1  - firmly, until fastener - 2  - engages in retainer tabs - 6  -.
• Install handle on parking brake lever.

2 - Fastener

3 - Mounts for trim

4 - Support bracket

• Removing 

• Remove parking brake lever trim - 1  -.
• Apply parking brake firmly.
• Remove two bolts - 5  - at support bracket - 4  - and remove support bracket.

• Installing 

• Apply parking brake firmly.
• Place support bracket to parking brake lever.
• Tighten bolts - 5  - by hand.
• Release parking brake.

• Tighten two bolts - 5  -.
• Install parking brake lever trim - 1  -.

5 - Bolts (2x)

• Tightening torque 4 Nm

6 - Retainer tabs