Supercharger, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2016 Audi S4, 2015 Audi S5, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
- Tightening specifications. Refer to OVERVIEW - SUPERCHARGER .
NOTE:
Replace the seals
The hose connections as well as the air guide pipes and hoses must be free of oil and grease before installing.
Secure all hose connections with hose clamps of the same type as those equipped by the factory.
To mount the air guide hoses on their connectors securely, spray the bolts on the used clamps with rust remover before installing.
-- Make sure the crankcase ventilation support is installed correctly when mounting the supercharger. Refer to Figure.
-- Install the supercharger ribbed belt. Refer to SUPERCHARGER RIBBED BELT, REMOVING AND INSTALLING .
-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING => Filling .