DSG Transmission MECHATRONIC -J743- Overview

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi S5, 2014 Audi S5, 2013 Audi S5, 2012 Audi S5, and 2011 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying DSG Transmission Mechatronic -J743- Overview

Courtesy of AUDI OF AMERICA, LLC

ATF Drain Plug
- Tightening specification, refer to Specifications
Seal
- Replace
Bolt
- Tightening specification and sequence, refer to Specifications
Expanding Rivet
- For attaching the gasket to the ATF oil pan
- Not required for installation
Magnet
- Quantity: 2
- Insert into the depression in the ATF oil pan
- Make sure the entire surface contacts oil pan
Bolt
- Tightening specification and sequence, refer to Specifications
O-rings
- Replace
ATF Pressure Pipes (coupling pressure)
Retaining Plate
- For the ATF pressure pipes (coupling pressure)
Bolt
- Tightening specification, refer to Specifications
O-rings
- Replace
O-rings
- Replace
ATF Oil Pipes
- Different versions, depending on date of manufacture
O-rings
- Replace
O-ring
- Replace
- Different versions, depending on date of manufacture
ATF Filter Housing
- For transmissions with a replaceable ATF filter
- Different versions, depending on date of manufacture
O-ring
- For transmissions with a replaceable ATF filter
- Replace
ATF Filter Cover
- For transmissions with a replaceable ATF filter
- Tightening specification, refer to ATF COOLER, ATF PIPES AND ATF FILTER OVERVIEW
ATF Filter
- Replace each time the ATF is changed and after performing a repair on the transmission
- Removing and installing, refer to ATF FILTER
Bolt
- For transmissions with a replaceable ATF filter
- Quantity: 3
- Tightening specification, refer to ATF COOLER, ATF PIPES AND ATF FILTER OVERVIEW
O-rings
- For transmissions with a replaceable ATF filter
- Replace
ATF Return Pipe
- For transmissions with a replaceable ATF filter
- Removing and installing, refer to ATF PIPES .
ATF Supply Pipe
- For transmissions with a replaceable ATF filter
- Removing and installing, refer to ATF PIPES .
Bolt
- For transmissions with a replaceable ATF filter
- Tightening specification, refer to ATF COOLER, ATF PIPES AND ATF FILTER OVERVIEW
Bolt
- For transmissions with an ATF pipe filter
- Quantity: 3
- Tightening specification, refer to ATF COOLER, ATF PIPES, ATF PIPE FILTER OVERVIEW
ATF Return Pipe
- For transmissions with an ATF pipe filter
- Removing and installing, refer to ATF PIPES
Bolt
- For transmissions with an ATF pipe filter
- Tightening specification, refer to ATF COOLER, ATF PIPES, ATF PIPE FILTER OVERVIEW
O-rings
- For transmissions with an ATF pipe filter
- Replace
ATF Pipe Connection
- For transmissions with an ATF pipe filter
ATF Pipe Filter
- Replace the ATF pipe filter whenever replacing the transmission or repairing the transmission
- Removing and installing, refer to ATF PIPE FILTER
ATF Fill and Check Plug
- Tightening specification, refer to Specifications
O-rings
- Replace
Bolt
- 8 Nm
Connector Housing
-- To remove, remove the bolt -33- and turn the connector housing counter-clockwise.
Transmission Housing
O-rings
- Replace
ATF Oil Pipes
Bolt
- Tightening specification, refer to Specifications
Cable Guide for the RPM Sensors
- Removing and installing, refer to Removal and Installation
O-ring
- Replace
ATF Suction Filter
- Removing and installing, refer to Removal and Installation
DSG Transmission Mechatronic -J743-
- Removing and installing, refer to DSG TRANSMISSION MECHATRONIC -J743-
  - Perform "Guided Functions" using the vehicle diagnostic tester after replacing the DSG transmission Mechatronic --, refer to TRANSMISSION GUIDED FUNCTIONS .
  - Separate the circuit board from the DSG transmission Mechatronic --. Refer to Removal and Installation
Gasket
- Replace
- Installing AUTOMATIC TRANSMISSION FLUID OIL PAN
ATF Pan
- Removing and installing, refer to AUTOMATIC TRANSMISSION FLUID OIL PAN