Overview - Camshaft Timing Chains: Notes
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi A5 Quattro, 2016 Audi A5 Quattro, 2015 Audi A5 Quattro, 2014 Audi A5 Quattro, and 2014 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 9 Nm
- Chain Tensioner
- Is under tension
- Remove the Locking Pin :T40011 before removing
- Timing Chain Tensioning Rail
- Guide Pin
- 20 Nm
- Bolt
- 9 Nm
- Control Valve
- 35 Nm
- Left-hand thread
- Depending on the version, remove with either the Central Valve Assembly Tool :T10352 or Central Valve Assembly Tool :T10352/1A
- Bolt
- Tightening Specifications and Sequence. Refer to Figure.
- Always replace after removing
- Washer
- Bearing Bracket
- Removing and installing. Refer to BEARING BRACKET, REMOVING AND INSTALLING
- Camshaft Timing Chain Guide Rail
- Camshaft Housing
- Camshaft Timing Chain
- Before removing, mark the running direction with paint
- Removing and installing. Refer to CAMSHAFT TIMING CHAIN, REMOVING AND INSTALLING
- Camshaft Timing Chain Guide Rail
- Guide Pin
- 20 Nm
- Three Stage Chain Sprocket
- Crankshaft
- Installation position. Refer to Figure.