Oil Spray Jets, Removing And Installing: Removing
Special Tools And Workshop Equipment Required
- Torx Bit - T40 :T10545
- Wrench - 21mm :T40263
- Adapter :T40314
Cylinder "1 to 3" :
- Transmission removed. Refer to TRANSMISSION, REMOVING AND INSTALLING (0B2) (SEDAN) / TRANSMISSION, ASSEMBLY SEQUENCE (0B2) (AWD - CABRIOLET) / TRANSMISSION, DISASSEMBLING AND ASSEMBLING (0B2) (CABRIOLET) / TRANSMISSION, DISASSEMBLING AND ASSEMBLING (0B2) (COUPE) / TRANSMISSION, ASSEMBLY SEQUENCE (0B2) (AWD - COUPE) or TRANSMISSION, REMOVING AND INSTALLING (0AW) (CABRIOLET) / TRANSMISSION, TRANSPORTING (0AW) (CABRIOLET) .
-- Remove the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .
- Only let the engine turn in the direction of engine rotation.
-- Turn the crankshaft with the : T40263 , :T40314 and the 24 mm socket in direction of -arrow- until the corresponding bolt is accessible.
Removing Cylinder "4" :
- The engine is removed and secured to the engine/transmission holder. Refer to ENGINE, SECURING TO ENGINE AND TRANSMISSION HOLDER .
-- Remove the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .
-- Remove the balance shaft timing chain. Refer to CAMSHAFT TIMING CHAIN, REMOVING AND INSTALLING .
-- Remove the connecting rod bearing cap.
-- Remove the crankshaft bearing cap.
-- Remove the crankshaft.
Continued for All Cylinders:
-- Remove the pressure relief valve -1- using the :T10545 .
-- Remove the oil spray jet -2-.