LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2009 >> A4 Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 1501 (Lubrication (Servicing) [CABB, CABA, CABD, CAEA, CAEB, CDHB, CDNB, CDNC, CDHA, CDZA, CADA, CCUA, CFKA, CPMA, CAED, CPMB, CHJA, CPEA] (Cabriolet)) >> Lubrication >> Oil Pan/Oil Pump >> Oil Pan Lower Section, Removing And Installing >> Removing

Oil Pan Lower Section, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi A5 Quattro, 2016 Audi A5 Quattro, 2015 Audi A5 Quattro, 2014 Audi A5 Quattro, and 2014 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

Depending on the model, preliminary work may be required. Refer to the appropriate service information in OIL PAN LOWER SECTION, REMOVING AND INSTALLING [CAEB, CAED, CPMA, CPMB] .

-- Disconnect the connector from the Oil Level Thermal Sensor -G266- -arrow-.

GWWA17-0215Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1 through 19-.

Fig 1: Oil Pan Lower Section Loosening Sequence
GWWA17-10413Courtesy of AUDI OF AMERICA, LLC

-- Remove the oil pan, if necessary loosen by applying light strikes with a rubber hammer.

-- If the oil pan lower section is replaced, remove the Oil Level Thermal Sensor -G266-. Refer to Oil Level Thermal Sensor -G266-, REMOVING AND INSTALLING .