Vibration Damper Seal, Replacing: Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi A5 Quattro, 2016 Audi A5 Quattro, 2015 Audi A5 Quattro, 2014 Audi A5 Quattro, and 2013 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the vibration damper. Refer To VIBRATION DAMPER, REMOVING AND INSTALLING .
- The :T10531/2 is installed.
-- Remove The Seal -Arrow- With The :T40274 .
-- Clean The Contact And Sealing Surface.
-- Push The Seal -Arrow- On The :T10354 .
- The Closed Side Of The Seal Points To The :T10354 .
-- Push The Seal -arrow- With The :T10354 On The :T10531/2 And Place On The Lower Timing Chain Cover.
-- Additionally Attach The :T10375 and tighten the :T10531/4 .
-- Drive The Seal In All The Way Using The :T10354 .
Further Installation Is Performed In Reverse Order Of Removal, While Noting The Following:
- Replace The Bolt With O-Ring For The Vibration Damper After Removal.
-- Install The Vibration Damper. Refer To VIBRATION DAMPER, REMOVING AND INSTALLING .