LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2009 >> A4 Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 1082 (Transmission System (Clutch - Service Information - 7-Speed Dual Clutch - 0CK, 0CJA, 0CLA, 0DN, 0DPA)) >> 30 Clutch >> Clutch >> Input Shaft Seal, Replacing >> Removing

Input Shaft Seal, Replacing: Removing

WARNING: This page is about a different car, the 2018 Audi A6, 2017 Audi A6, and 2016 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

There Is A Risk Of Damaging The Clutch From Mishandling.

  • The shaft seal can only be replaced when the clutch is installed. Refer to Removing 

-- Pry out the shaft seal -arrow- carefully with the :T20143  .

GWWA30-10333Courtesy of AUDI OF AMERICA, LLC
NOTE:

Do not damage the contact surface on the shaft.

scientia non olet · About LEMON Manuals