Headlamps, removing and installing: Installing
Install in reverse order of removal, noting the following:
- Check adjusting nut - 1 - of adjuster for freedom of movement - arrows -.
- Screw adjusting nut as far as it will go, but do not tighten.
- Insert headlamp and screw in screws - 1... 3 - two complete turns.
- Install front bumper cover → 63 BUMPER .
- Align headlamp with body contours and front bumper cover (note gap widths).
- Tighten screws in sequence - 2 - , - 1 - and - 3 -.
NOTE:
- When the screws are tightened the adjusting nut of the adjuster element automatically rotates against the mounting point of the headlamp housing and fixes it in place.
- Check gaps; if necessary, repeat procedure for installing headlamp.
- Reconnect battery. Required steps Audi A4 S4 Reconnecting . Required steps Audi RS4 Connecting
- Following installation, check and adjust headlamps if necessary → 00 - TECHNICAL DATA .
Tightening torque
| Component - fastener | Nm |
| Headlamp to lock carrier - screw | 4.5 |