Low Beam Headlamp M29 / M31 - bulb, replacing
Removing
- Turn light switch to position "0".
CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
Left headlamp:
- Remove headlamp → Headlamps, removing and installing .
Right headlamp - vehicles with 1.8L 4-cylinder Turbo engine:
- Preparation.
Right headlamp - vehicles with 3.0L 6-cylinder engine:
- Preparation.
Both sides, continued
- Release retaining clip - arrow - and detach housing cover for low beam from headlamp housing.
- Disconnect electrical connection - 2 - at low beam bulb.
- Disengage retaining clip - 1 - and remove bulb - 3 - from housing.
Installing
Install in reverse order of removal, noting the following:
CAUTION:
- Do not touch glass portion of bulb with bare hands. Even the smallest amount of moisture and/or contaminants from fingers that evaporates on the bulb during operation can cause the glass to cloud over.
- When installing housing cover, ensure proper seating. Water intrusion will damage headlamp.
- Insert bulb and secure with retaining clip.
- Secure housing cover with retaining clip.