Fan shroud, removing and installing

Removing

Fig 1: Removing Engine Cover

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove engine cover - arrows -.
Bring lock carrier into service position → Lock carrier, moving into service position .
Remove engine cover - arrows -.

Fig 2: Removing Electrical Harness Connectors From Bracket

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove electrical harness connectors - 1 - and - 2 - from bracket and disconnect them.
Free up electrical wiring.

Fig 3: Removing Bolts And Fan Shroud Upward And Out

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Installing

Installation is in reverse order of removal, note the following:

Install lock carrier with attachments →
- 50 BODY, FRONT
- 50 - BODY - FRONT for BODY EXTERIOR - CABRIOLET
.

Fig 4: Identifying Lock Carrier With Attachments

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Place torque support stop onto rubber buffer for torque support under its own weight and tighten nuts - arrows -.
Install front bumper cover →
- 63 BUMPER
- 63 - BUMPERS for BODY EXTERIOR - CABRIOLET
.
Check headlight adjustment →
- 01 - MAINTENANCE
- 01 - MAINTENANCE for MAINTENANCE PROCEDURES - CABRIOLET
.

Torque specifications