9-position relay carrier, removing and installing
Removing
CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Where applicable, remove drivers storage compartment → 68 - INTERIOR EQUIPMENT .
- Remove nuts - 3 - remove Vehicle Electrical System Control Module J519 with wires attached.
- Remove 9-position relay carrier - 4 -.
NOTE:
- Disregard - 1 - and - 2 -.
- Unclip the fuse carriers at the 9-position relay carrier.
- Remove relays and control modules and then unclip appropriate relay carrier.
NOTE:
- Refer to the applicable wiring diagram for exact identification of connections on relay carrier Wiring Diagrams.
Installing
Install in reverse order of removal, noting the following:
- Install drivers storage compartment → 68 - INTERIOR EQUIPMENT .
Tightening torque
| Component - fastener | Nm |
| 9-position relay carrier to central tube for instrument panel - nut | 2.4 |