Rear light/bulb carrier - Avant, removing and installing
Removing
- Turn light switch to position "0".
CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Remove plug - arrow - from luggage compartment lining.
- Remove screw - 1 -.
- Swivel rear light outwards, and at the same time disengage retaining pins from body.
- Disconnect electrical connection at bulb carrier.
- Press apart retaining clips - arrows - and take bulb carrier out of rear light.
- Turn bulbs to remove them from their holders.
Installing
Install in reverse order of removal, noting the following:
NOTE:
- Ensure seal between body and rear light housing seals completely.
- Fit rear light in position on body and press retaining pins into holes.
- Tighten screw - 1 -.
NOTE:
- After loosening nut - 2 - , rear light can be aligned with body contours (uniform gap widths).
Tightening torques
| Component - fastener | Nm |
| Rear light to body - nut | 12 |
| Rear light to body - screw | 6 |