Rear light/bulb carrier in rear lid - Sedan, removing and installing
Removing
- Turn light switch to position "0".
CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Unclip plug - 1 - from luggage compartment trim - arrow - using a small screwdriver.
- Remove nut - 3 - and remove retainer - 2 -.
- Press inner rear light - 1 - towards - arrow - (working from inside of rear lid) until light can be removed from the outside.
- Disconnect electrical connection at bulb carrier.
Installing
Install in reverse order of removal, noting the following:
NOTE:
- Ensure seal between body and rear light housing seals completely.
- Position inner rear light at outer edge of rear lid.
- Push on retainer at stud for inner rear light and tighten nut.
NOTE:
- As the nut is tightened the retainer becomes wedged at the inner rear light and the rear lid.
- Clip plug into luggage compartment lining.
Tightening torque
| Component - fastener | Nm |
| Inner rear light to body - nut | 3.5 |