LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2009 >> A4 Base, 2D Convertible >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Electrical Equipment >> 94 Lights, Switches - Exterior >> Rear Lights - from 11.04 >> Rear light/bulb carrier in rear fender - Sedan, removing and installing

Rear light/bulb carrier in rear fender - Sedan, removing and installing

Removing 

CAUTION:
  • Switch off all electrical consumers.
  • Switch ignition off and remove ignition key.
Fig 1: Identifying Pre-punched Area Of Luggage Compartment Lining, Fastener, And Rear Light
GW00021699Courtesy of VOLKSWAGEN UNITED STATES, INC.
Fig 2: Pressing Together Retaining Tabs And Removing Bulb Carrier From Rear Light
GW00021700Courtesy of VOLKSWAGEN UNITED STATES, INC.

Installing 

Install in reverse order of removal, noting the following:

NOTE:
  • Ensure seal between body and rear light housing seals completely.
  • Fit rear light in position on body and press retaining pins into holes.

Tightening torque 

Component - fastener Nm
Rear light to body - screw 3.5