Ignition/starter switch, removing and installing

Removing

Remove steering column switch module → Steering column switch module, removing and installing .
Disconnect electrical connection at immobilizer reader coil.

Fig 1: Locating Screws , Ignition/Starter Switch And Steering Lock Housing

GW00017095

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical connection - 1 - at ignition/starter switch.
Remove sealing paint from both securing screws - arrows -.
Loosen bolts - arrows - (do not remove) and pull ignition/starter switch out of steering lock housing - 2 -.

Installing

Install in reverse order of removal, noting the following:

NOTE:

Ensure that the ignition/starter switch and lock cylinder are in the same position, e.g. "Ignition ON" , when installing.
Apply sealing paint to bolts - arrows - at steering lock housing - 2 -.
Install steering column switch module Installing .